ERROR CODES TABLE
The electronic system continually performs a series of diagnostic tests. If some parameters are incorrect, the control unit deactivates the functions and displays an error code (Err followed by three numerical digits); all the heating elements are turned off, including the fan inside the cooking chamber. The cooling fan remains on.
Take note of the error code and contact an Authorized Service Centre, specifying the error code.
Error Code | Cause | SOLUTION | |
Err | 001 | BOILER overheat | Check that there is water in the |
|
| The causes of this alarm are: | pitcher. |
|
| The fill pump does not pour the water from | Turn the oven off and on again. |
|
| the pitcher to the boiler. | If the failure repeats, take note of |
|
| The causes may be: | |
|
| a – empty pitcher | the error code and contact an |
|
| b – a leak in the hydraulic circuit | Authorized Service Centre, |
|
| c – broken pump | specifying the error code. |
|
| d – electronic failure in the power circuit |
|
|
| (relay or relay control) |
|
Err | 002 | Boiler protection alarm. | Take note of the error code and |
|
| The system | contact an Authorized Service |
|
| in advance, and thus all the loads | Centre, specifying the code. |
|
| connected to it. | |
|
|
| |
|
| - Replace the power card |
|
Err | 003 | Power card overheat: threshold value | Check whether the oven is |
|
| >=85° | embedded in the furniture |
|
|
| according to the instructions in this |
|
|
| handbook. |
|
|
| Check whether the tangential fan is |
|
|
| operating correctly. |
Err | 004 | PT1000 cooking chamber sensor | Contact an Authorized Service |
|
| Cause: interruption or short circuit of the | Centre, specifying the code. |
|
| sensor or cables. |
|
|
| - Replace the PT1000 |
|
Err | 005 | Food sensor | Contact an Authorized Service |
|
| Cause: interruption or short circuit of the | Centre, specifying the code. |
|
| sensor or cables. |
|
|
| - Check the electrical connections. |
|
|
| - Replace the food probe. |
|
Err | 006 | Boiler thermocouple failure Cause: open | Contact an Authorized Service |
|
| circuit or short to earth. | Centre, specifying the code. |
|
| - Replace the BOILER. |
|
Err | 007 | Cooking chamber steam presence | Contact an Authorized Service |
|
| thermocouple failure Cause: open circuit | Centre, specifying the code. |
|
| or short to earth. |
|
|
| - Replace the TC1. |
|
Err | 008 | Cooking chamber overheat | Contact an Authorized Service |
|
| - Replace the power card | Centre, specifying the code. |
Err | 009 | Failure of the ntc sensor on the power | Contact an Authorized Service |
|
| card Cause: open circuit or short. | Centre, specifying the code. |
|
| - Replace the power card |
|
83