Fostex D-108 owner manual Turn the JOG dial to select the desired sampling frequency

D-108 Quick Operation Guide

<Notes on setting the sampling frequency>

•Selecting a sampling frequency of 48kHz will cause the hard disk space to be used more than the setting of 44.1kHz, and the available recording time will be shorter. This will be reflected on the REMAIN value.

•Do not change the sampling frequency during a session (except for a special case). If you change the setting, data will be played at different speeds and the values stored in the memory keys (time value or bar/beat/clock) will be changed.

The following procedure assumes that the D-108 is powered on and the top of Program 1 (ABS 0) is located and shown on the display.

<Sampling frequency menu>

•	Default setting: 44.1kHz	•	The setting can be saved and loaded as part of the song data.
•	Options: 44.1kHz, 48kHz	•	The setting is stored after the power is turned off.
• The frequency can be set for each Program.

1.Press the DISP SEL key repeatedly to select the SETUP mode display.

Pressing the key twice will change the display from the REMAIN indication to the SETUP display. ([SETUP] flashes.)

							ABS
OL
0
3
6							44.1kHz
9
12
18
24
30
42
∞
1	2	3	4	5	6	7	8

REMAIN

OL

0

3

6

944.1kHz

12

18

24

30

42

∞

4. Press the EXECUTE/YES key.

The display changes as follows and the current sampling frequency value (44.1 or 48) flashes.

							SETUP
OL
0
3
6							44.1kHz
9
12
18
24
30
42
∞
1	2	3	4	5	6	7	8

5.Turn the JOG dial to select the desired sampling frequency.

As you turn the dial, two sampling frequencies toggle.

1	2	3	4	5	6	7	8
							SETUP
OL
0
3
6							44.1kHz
9
12
18
24
30
42
∞
1	2	3	4	5	6	7	8

2. Press the EXECUTE/YES key

The display shows the first layer of the SETUP mode menu. (With the default setting, the [Drive Sel.? ] menu appears.)

								SETUP
OL
0
3
6								44.1kHz
9
12
18
24
30
42
∞
1	2	3	4	5	6	7	8

							SETUP
OL
0
3
6							44.1kHz
9
12
18
24
30
42
∞
1	2	3	4	5	6	7	8
							SETUP
OL
0
3
6							44.1kHz
9
12
18
24
30
42
∞
1	2	3	4	5	6	7	8

6.Press the EXECUTE/YES key.

The selection of the sampling frequency is confirmed.

3.Turn the JOG dial to select the [SampleRate?*** (setting the sampling frequency) ] menu.

The SETUP menu title and the current sampling frequency (44.1kHz or 48kHz) appear on the display. (With the default setting, the sampling frequency is set to 44.1kHz.) You can use the SHUTTLE dial or the HOLD/> key to select the menu.

								SETUP
OL
0
3
6
9								44.1kHz
12
18
24
30
42
∞
1	2	3	4	5	6	7	8

7.Press the EXIT/NO key or the STOP button to quit SETUP mode.

The previous Time Base indication appears and the selected sampling frequency value lights up on the display.

20