SMC Networks SMC2555W-AG manual Using the Web-based Management Setup Wizard

Initial Configuration

accessed using Telnet from any computer attached to the network.

Setting the Country Code – Units sold in the United States are configured by default to use only radio channels 1-11 as defined by FCC regulations. Units sold in other countries are configured by default without a country code (i.e., 99). You must use the CLI to set the country code. Setting the country code restricts operation of the access point to the radio channels permitted for wireless networks in the specified country.

Type “exit” to leave configuration mode. Then type “country ?” to display the list of countries. Select the code for your country, and enter the country command again, following by your country code (e.g., IE for Ireland).

SMC Enterprise AP#country ie

SMC Enterprise AP#

Using the Web-based Management Setup Wizard

There are only a few basic steps you need to complete to connect the SMC2555W-AG to your corporate network, and provide network access to wireless clients. The Setup Wizard takes you through configuration procedures for the wireless Service Set Identifier, the radio channel selection, and IP configuration.

The SMC2555W-AG can be managed by any computer using a web browser. Enter the default IP address: http://192.168.2.2

4-4