System Configuration

authentication. To view the current 802.11g security settings, use

the show interface wireless a or show interface wireless g

command (not shown in example).

SMC-AP(config)#interface wireless g

6-68

Enter Wireless configuration commands, one per line.

 

SMC-AP(if-wireless g)#authentication open

6-83

SMC-AP(if-wireless g)#encryption 128

6-84

SMC-AP(if-wireless g)#wpa-clients required

6-90

SMC-AP(if-wireless g)#wpa-mode pre-shared-key

6-92

SMC-AP(if-wireless g)#wpa-psk-type alphanumeric

6-94

SMC-AP(if-wireless g)#wpa-preshared-key ASCII asecret 6-93

SMC-AP(if-wireless g)#end

 

SMC-AP(config)#no

802.1x

6-51

SMC-AP(config)#no

mac-authentication

6-57

CLI Commands for WPA over 802.1x Security – From the 802.11a or 802.11g interface configuration mode, use the authentication command to set the access point to “Open System.” Use the WEP encryption command to enable all types of encryption. Use the wpa-clientscommand to set WPA to be required or supported for clients. Use the wpa-modecommand to enable WPA dynamic keys over 802.1x. Set the broadcast and multicast key encryption using the multicast-ciphercommand. Then set 802.1x to required, and disable MAC authentication. To view the current 802.11g security settings, use the show interface wireless g command (not shown in example).

SMC-AP(config)#interface wireless g

6-68

Enter Wireless configuration commands, one per line.

 

SMC-AP(if-wireless g)#authentication open

6-83

SMC-AP(if-wireless g)#encryption 128

6-84

SMC-AP(if-wireless g)#wpa-clients required

6-90

SMC-AP(if-wireless g)#wpa-mode dynamic

6-92

SMC-AP(if-wireless g)#multicast-cipher TKIP

6-89

SMC-AP(if-wireless g)#end

 

SMC-AP(config)#802.required

6-51

SMC-AP(config)#no mac-authentication

6-57

 

 

5-62

Page 120
Image 120
SMC Networks SMC2555W-AG manual Show interface wireless a or show interface wireless g, Command not shown in example