MR16 Owner’s Manual (Part editing)
Part editing
This chapter describes how to edit a "part" (*) of recorded song.
You can edit data of a track or tracks between the "LOCATE A" and "LO- CATE B" points. Part editing does not consume the hard disk space. Therefore, the remaining space of the disk does not change by executing part editing.
<(*) About "part">
A "part" is defined as audio data between the "LOCATE A" and "LOCATE B" points. You can edit a "part" as described later.
Therefore, before carrying out part editing, the "LOCATE A" and "LOCATE B" points must be set. See page 53 for details about how to set these points.
<Undo/redo of editing>
You can undo part editing. By pressing the [UNDO/REDO] key after executing part editing, the song returns to the original condition before editing.
By pressing the [UNDO/REDO] key after undoing part editing, you can again return the song to the condition after being edited.
UNDO/REDO
[UNDO/REDO] key
<Notes>
Also note that if you carry out any of the following after editing, you cannot undo the editing anymore.
1.Making new recording
2.Making new editing
3.Turning off the power
4.Loading another song
<Notes>
While a menu screen is shown, you can go up the menu screen level or directly exit the menu mode by the following operations.
(1)Select “ 
Back” on a menu screen and press the [MENU/ENTER] knob.
The display returns to the previous (upper level) screen. Repeating this operation finally exits the menu mode.
(2)Press the [REWIND] key.
The display returns to the previous (upper level) screen. Repeating this operation finally exits the menu mode.
(2)Press the [STOP] key.
The menu mode exits and the display shows the home screen.
