MR16 Owner’s Manual (Track bouncing)
Panning setting for INPUT A through INPUT D
You can independently set panning for each of INPUT A through INPUT D.
Each input signal is positioned in the mix according to the panning setting here.
1)While the recorder is stopped, press the [MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the menu selection screen.
3)Rotate the [MENU/ENTER] knob to select the desired item (any one of "Input A Pan" through "Input D Pan"), and press the [MENU/ENTER] knob.
The display shows the screen for making pan- ning setting of the selected input. The current setting flashes.
In the screen example below, "Input A Pan" is se- lected and the default "CNT" is flashing.
2) Rotate the [MENU/ENTER] knob to select "Input 
" on the second page, and press the [MENU/ENTER] knob.
The display now shows the input menu screen.
Flashing
The default panning settings are as below. You can set each input to the desired panning position from L10 (hard left) to R10 (hard right).
Input A | CNT (center position) |
|
|
Input B | CNT (center position) |
Input C | CNT (center position) |
Input D | CNT (center position) |
|
|
<Tip>: You can directly access to the input menu screen by a long press of the [TO STE- REO BUSS] key of the desired input chan- nel. On the input menu screen accessed in this way, the panning setting item for the corresponding input is highlighted.
For example, a long press of the [TO STE- REO BUSS] key of [INPUT D] directly accesses to the screen shown below.
Flashing
You can select the desired panning value from among R01 through R10 and L01 through L10, as well as "CNT" (center).
4)Rotate the [MENU/ENTER] knob to select the desired value, and press the [MENU/ENTER] knob.
The panning is set and the display returns to the previous screen.
In the screen example below, "Input A Pan" is set to "R10".
Flashing
You can also make panning setting of another input in the same manner as above.
5)Press the [STOP] key to exit the menu mode.
By selecting "
Back" and pressing the
[MENU/ENTER] knob, the display returns to the previous screen.
Therefore, you can also exit the menu mode by repeating this operation.
86
