![](/images/new-backgrounds/1229348/229348283x1.webp)
MR16 Owner’s Manual (Other functions)
Pre-roll/post-roll time setting
As described earlier on page 51, when both the auto punch in/out and loop modes are active, the
When both the auto punch in/out and loop modes are ac- tive, the loop starts from "the LOCATE A point minus the
In other words, with the default
LOCATE A | LOCATE B |
Point | Point |
|
|
|
|
|
| 4 sec. |
|
|
| 1 sec. |
|
|
|
|
| ||||||
|
| |||||||
LOOP START |
| LOOP END | ||||||
| point |
| point |
1) While the recorder is stopped, press the [MENU/ENTER] knob to enter the menu mode.
The display now shows the first page of the menu selection screen.
Flashing |
2) Rotate the [MENU/ENTER] knob to select "System ", and press the [MENU/ENTER] knob.
The display now shows the first page of the
system menu screen. | 4) | Rotate the [MENU/ENTER] knob to select the |
|
|
pre-roll hold time, and press the [MENU/ENTER] knob.
The
To set the
5) Rotate the [MENU/ENTER] knob to select "Post Roll Time" and press the [MENU/ENTER] knob.
The currently selected
You can select between "0.1s" and "10s" in 0.1 second steps.
3)Rotate the [MENU/ENTER] knob to select "Pre Roll Time=*.*s" and press the [MENU/ENTER] knob.
The currently selected
You can select between "0.1s" and "10s" in 0.1 second steps.
6)Rotate the [MENU/ENTER] knob to select the
The
7)Press the [STOP] key to exit the menu mode.