Model VM08 Owner’s Manual 
<CAUTION>
If [Fader Fix mode], discussed below, in the [Setup mode] is set to [ON], no signal will be output even though the fader is moved. The [FADER FIX mode] is set to [OFF]. For details refer to [Setup mode] on page 27.
Mute of the various input channel/master output:
Mute ON/OFF of channels 1 ~ 4, 5/6, 7/8 and master output can be done using the CH ON/CH SEL key. Normally, the CH ON/CH SEL keys for channels 1 ~ 4, 5/6, 7/8 and MASTER are all ON (key LED is lit). Therefore, when the CH ON/CH SEL key of the channel you wish to mute is pressed, sound from that channel only will be muted (the CH ON/CH SEL key LED of the channel that was pressed will be extinguished). Mute ON/OFF alternates with each pressing of the CH ON/CH SEL key.
Mute ON channel (LED is off).
<Useful information !>
In addition to operating with the CH ON/CH SEL key, mute ON/OFF of master output is also possible using the foot switch (Optional Model 8051).
In the foot switch functional setting is set for [Mute function of master output] in the [Setup mode] of the VM08, mute can be executed by stepping on the foot switch. For details on the [Setup mode], please refer to page 27.
<Useful information !>
In the normal mix mode, if the position of the INPUT fader/MASTER fader before switching off power is different from when power is switched on (refer to schematic below), the FADER ADJUST and LEVEL ADJUST key LED’s (red) will flash. This is because the fader setting before switching off power is in memory, and the VM08 is indicating that fader and level adjustment is possible.
The fader position can be reset to the position prior to switching off power, and the level position can be deliberately set to the present sound volume setting.
* To return to the setting before switching off power:
Press the flashing FADER ADJUST key (It will enter the fader adjust mode). Subsequently, adjust each fader position by referring to [Fader adjust mode] explanation.
* To set to the present fader position:
Press the flashing LEVEL ADJUST key and the VM08 will enter the level adjust mode. Then setup by following [Level adjust mode] on page 27.
If it is not necessary to match the fader positions, the FADER ADJUST key flashing will extinguished after all faders are moved and the VM08 will return to the normal mix mode.
<Setting before switch off of power> | <Setting at switch on again of power> |
13
