Model VM08 Owner’s Manual

1.Status display section [E1] or [E2] dots are lit by pressing the EFF/AUX key.

The LCD will display the following:

Example: Character section when [E1] is lit.

[1-Eff1:00] is displayed. Channel 1 EFFECT SEND 1 level can now be adjusted. The present EFFECT SEND 1 level setting is "dry" (0).

Lit

2.Select the channel to be adjusted by pressing the desired CH ON/CH SEL key.

3.Adjust the number with the DATA encoder.

The number will change in a [0] ~ [99] range and the depth of effects will also change. The graphic display will change at the same time.

[00]~ [99] will be displayed.

Bar graph extends in step by blinking.

<Useful information!>

If channels 5/6 or 7/8 are selected, the two channels will be set at the same time. If MAS- TER is selected, the effect send level master can be adjusted and the L, R meter used to indicate the level.

Setup method of the AUX SEND level

Adjusting the signal level output from the VM08 rear panel AUX SEND jack (1/2).

The adjusted signal is sent to external equipment (external effects and monitor amplifier) from the AUX SEND jack. The same as with the EFFECT SEND signal, either POST or PRE can be selected for the AUX SEND signal. The VM08 is set to POST in the initial state. To change the setting, please see below [Setup of PRE/POST].

1.Light up the [A1] or [A2] dots in the status display section but pressing the EFF/AUX key.

The LCD will display the following:

Example: The character display section with light up [A1].

[1-Aux1:00] is displayed. Now, channel 1 AUX SEND 1 level can be adjusted. This also indicates that the present AUX SEND 1 level setting is MIN (00).

3.Adjust the number with the DATA encoder.

The number will change in the [0] ~ [99] range and depth of effects will also change. The graph- ics display will change at the same time.

[00]~ [99] will be displayed.

Lit

Bar graph extended in step with blinking.

2.Press the desired CH ON/CH SEL key and select the channel you wish to adjust.

<Useful information!>

When channels 5/6 or 7/8 are selected, the two channels will be set at the same time. If MAS- TER is selected, the effect send level master can be adjusted and the L, R meter used to display the level.

16

Page 16
Image 16
Fostex VM08 owner manual Setup method of the AUX Send level, Example Character section when E1 is lit