Freescale Semiconductor DSP56366 9.3.1 ESAI_1 Multiplex Control Register (EMUXR), 9.3.2 ESAI_1 Transmitter Clock Control Register (TCCR_1)

ESAI_1 Programming Model
DSP56366 24-Bit Digital Signal Processor User Manual, Rev. 4
Freescale Semiconductor 9-5
The ESAI_1 also contains the GPIO Port E functionality, described in Section 9.5, "GPIO - Pins and
Registers". The following paragraphs give detailed descriptions of bits in the ESAI_1 registers that differ
in functionality from their descriptions in the ESAI Programming Model.
9.3.1 ESAI_1 Multiplex Control Register (EMUXR)
The read/write ESAI_1 Multiplex Control Register (EMUXR) controls which peripheral (ESAI or
ESAI_1) is using the shared pins.
Hardware and software reset clear all the bits of the EMUXR register. The selection of ESAI/ESAI_1 pins
is shown in Tabl e 9-1.
9.3.2 ESAI_1 Transmitter Clock Control Register (TCCR_1)
The read/write Transmitter Clock Control Register (TCCR_1) controls the ESAI_1 transmitter clock
generator bit and frame sync rates, the bit rate and high frequency clock sources and the directions of the
FST_1 and SCKT_1 signals. In synchronous mode, the bit clock defined for the transmitter determines the
receiver bit clock as well. TCCR_1 also controls the number of words per frame for the serial data.
Hardware and software reset clear all the bits of the TCCR_1 register.
11109876543210
Y:$FFFFAF EMUX3 EMUX2 EMUX1 EMUX0
23 22 21 20 19 18 17 16 15 14 13 12
Reserved bit - read as zero; should be written with zero for future compatibility.
Figure 9-2 EMUXR Register
Table 9-1 EMUXR ESA/ESAI_1 Pin Selection
EMUXR bit ESAI pin ESAI_1 pin
EMUX0 0 SDO0 [PC11] disconnected
EMUX0 1 disconnected SDO0_1 [PE11]
EMUX1 0 SDO1[PC10] disconnected
EMUX1 1 disconnected SDO1_1 [PE10]
EMUX2 0 SDO2/SDI3 [PC9] disconnected
EMUX2 1 disconnected SDO2_1/SDI3_1 [PE9]
EMUX3 0 SDO3/SDI2 [PC8] disconnected
EMUX3 1 disconnected SDO3_1/SDI2_1 [PE8]