Friedrich WS10B10 Electronic Control Operation, To adjust fan speed, To set the hour clock

ELECTRONIC CONTROL OPERATION

PM

Power

Fan		Cool
	Mode	Money Saver®
Speed
		Fan Only
		Clock
Timer	Set	Start Time
On/Off	Hour	Stop Time	Temp/Hour

PM

2	3	4
8
9		Smart	Fan	Mode
		Fan	Speed
14		Money	Timer	Set
		Saver	On/Off	Hour
13
10	11	12

Power1

Cool

Fan Only 6

Heat

7

Clock

Start Time 5

Stop Time

Temp/Hour

Figure1:1:WSWSModelModelcoolcool-only -controllycontrolpa e panel

To start unit

If the air conditioner is installed and plugged into a proper receptacle, it is ready to go. The first time the unit is started, the compressor will delay for three minutes. See Automatic Component Protection on the following page.

1Touch the Power button once. The unit will automatically be in Cool mode with the temperature set at 75°F (24°C) and the fan speed at F1, the sleep setting.

To set mode of operation

When you first turn the unit on, it will be in the Cool mode with constant fan.

Figure2:2:WY/WEModelModelheat-heatcool control-cool controlpa el panel

6WARMER – Touch thebutton to raise the room air temperature.

7Press both the and buttons at the same time to switch the temperature from Fahrenheit (°F) to Celsius (°C). Repeat Step 7 to switch from °C back to °F.

To adjust fan speed

8Touch the Fan Speed button to see the current setting. Touch it again t o change s peed. F1 i s the lowest setting (SLEEP SETTING / LOW), F2 is MEDIUM, and F3 is HIGH.

2On WS cool-only models, touch the Mode button once to activate the MoneySaver® (See item 14 for MoneySaver instructions on WY/WE models).

MoneySaver® is a feature that cycles the fan with the compressor so that the fan does not run all the time. This saves energy and improves dehumidification. MoneySaver® will also run to test the temperature if the off cycle is too long. Or you may prefer constant fan for more air movement. (To return to constant fan, touch the Mode button two more times).

In order to run the fan by itself, do the following:

On WY/WS heat-cool models, touch the Mode button once to activate the Fan Only feature. The Fan Only setting will circulate air in the room without the compressor coming on.

3Continuing from MoneySaver® mode, touch the Mode button once to activate the Fan Only feature (WS cool-only models).

To adjust temperature

4Use the Mode button to select either the Cool or MoneySaver® function (or Heat for WY/WE heat-cool models)

5COOLER – Touch the button to lower the room air temperature.

To activate Smart Fan(WS cool-only models)

9There is a fourth option, SF, when selecting the fan speed. This is the SMART FAN function. SMART FAN DOES NOT OPERATE IN CONJUNCTION WITH THE FAN ONLY MODE.

To activate Smart Fan(WY/WE heat-cool models)

9Press the Smart Fan button to activate the Smart Fan.The light will indicate that this feature is in use.

Smart Fan will adjust the fan speed automatically to maintain the desired comfort level. For example, if the outside doors in your home are opened for an extended period of time, or more people enter a room, Smart Fan may adjust to a higher fan speed to compensate for the increased heat load. This keeps you from having to adjust the fan speed on your own.

To set the hour clock

10Touch t he Set Hour button to see t he c urrent setting. T he number that is displayed is the approximate time (hour only). Use the and buttons to change the settings. BE SURE TO SET A.M. AND P.M. ACCORDINGLY. (P.M. is indicated by a red light in the upper left corner of the display).

8