To set the timer
NOTE: Set the HOUR CLOCK (Set Hour) before attempting to set timer functions.
You can set the Start Time and Stop Time a minimum of one hour apart, and a maximum of 23 hours apart.
11After setting the time, press the Set Hour button once (Start light on). Use the 
and 
buttons to select the time that the unit will START.
12After selecting the Start Time, press the Set Hour button once. (Stop Light on). Use the 
and 
buttons to select the time that the unit will STOP. After selecting the stopping time, press the Set Hour button once.
13Press the Timer On/Off button (light turns on) to activate the timer function. To deactivate this function, press the Timer On/ Off button once again (light turns off). Once the on and off times have been selected, they will remain in memory and cycle daily until changed.
NOTE: If the unit is unplugged or the power is interrupted, the HOUR must be reset or the Timer On/Off will not function when desired.
To Activate Money Saver (WY/WE models)
14Press the Money Saver button to activate the Money Saver feature. The light will indicate the Money Saver is in use.
MoneySaver® is a feature that cycles the fan with the compres sor so that the fan does not run all the time. This saves energy and improves dehumidification. MoneySaver® will also run to test the temperature if the off cycle is too long. Or you may prefer constant fan for more air movement. (To return to constant fan, touch the Mode button two more times).
CHECKING ROOM TEMPERATURE
1.Check the room temperature at the electronic control pad by pressing at the same time, the Fan Speed
button and the Temp/Hour 
button (see figures 1 and 2).
2.The indoor temperature will display for 10 seconds. Indoortemperaturecanbeviewedinallmodes,including the Test Mode. The display can be changed back to the SET temperature by pressing any key (except the Power (on/off button) or it can do so automatically after
10 seconds have elapsed.
9
