c:Press down on top of thermopile, forcing it out of the pilot bracket.
a:Remove these screws to release guard.
b:Bend this clip outward to release thermopile.
3.To replace only the thermopile in fryers with the current design pilot assembly (see illustration below), use a 7⁄16-inch open-end wrench to loosen the thermopile, then unscrew it from the pilot assembly. Screw the replacement into the pilot assembly and use a wrench to tighten it ¼-turn past finger tight.
Ferrule on thermopile unscrews from bottom of pilot.
3.To replace the complete pilot assembly of either design:
a.Disconnect the pilot tubing from the bottom of the pilot assembly.
b.Disconnect the thermopile lead(s) from the gas valve pilot coil.
c.Remove the screw(s) from the
d.Reverse steps a through c to install the replacement pilot assembly.
4.Reinstall the burner assembly by reversing steps
