4.2.2Preparation for Use with the Magnasol Filter Assembly

1.Pull the filter pan out from the cabinet and remove the crumb screen and Magnasol filter assembly.

The filter pan is equipped with rollers in rails, much like a kitchen drawer. The pan may be removed for cleaning or to gain access to interior components by lifting the front of the pan to disengage the front rollers, then pulling it forward until the rear rollers clear the rails. The pan cover must not be removed except for cleaning, interior access, or to allow a shortening disposal unit (SDU) to be positioned under the drain.

NOTE: Refer to Section 4.4 for instructions on how to disassemble and reassemble the Magnasol filter screen assembly.

2.Inspect the fitting on the bottom of the Magnasol filter assembly to ensure that the O-ring is present and in good condition.

Remove the crumb screen and filter assembly from the pan. Clean all components with a solution of detergent and hot water, then dry thoroughly.

Inspect the filter screen O-ring.

3.Inspect the filter pan connection fitting to ensure that both O-rings are present and in good condition.

Inspect the filter connection fitting O-rings.

4-5