4.4Disassembly and Reassembly of the Magnasol Filter Dissassembly

1.Grasp the frame with your thumbs on the handles at the corner of the assembly and pull outward in opposite directions to separate the frame at the corner. Continue to open the frame (it will

pivot at the opposite corner) until the outer screens and grid can be removed from the frame.

Step 2 - Separate the outer screens and grid.

Step 1 - Grasp frame with thumbs on these handles and pull frame appart at corner.

2. Separate the outer screens and grid.

Cleaning

1.Daily – Clean the outer screens, grid, and frame using a good quality degreaser and hot water from a spray nozzle. The groove in the seal frame pieces can be cleaned with the edge of a Scotch-Brite™ or similar cleaning pad.

Allow all filter assembly components to air dry or thoroughly dry with clean towels before reassembling.

2.Additionally, at each scheduled boil-out, disassemble the leaf filter assembly and place in the frypot being boiled out. Follow the boil-out procedure in Section 5.1.2 of this manual.

Reassembly

1.Place the two outer screens together and align their edges (see illustration on following page).

2.Insert the screens into one of the frame halves (it doesn’t matter which one). Ensure that the fitting in the bottom screen is on the opposite side of the frame from the handle.

3.Slip the grid between the screens, ensuring that the grid is centered between the edges of the screens.

4.Connect the other half of the frame at the corner opposite the handles and pivot the frame onto the free edges of the screen.

4-9