PROBLEM | PROBABLE CAUSES |
| CORRECTIVE ACTION |
|
| A. Disconnect unit from electrical | |
| A. Temporary controller malfunction |
| power, wait at least one minute, |
|
| reconnect unit to the power | |
| caused by voltage surge. |
| |
|
| supply and turn controller on. | |
|
|
| |
CM III will not go |
|
|
|
| B. | If available, substitute controller | |
into programming |
| ||
|
| known to be good for suspect | |
mode. |
|
| |
|
| controller (see Section 6.6). If | |
|
|
| |
| B. Failed controller. |
| fryer operates normally, order |
|
|
| replacement controller from |
|
|
| FASC. |
|
|
| |
|
| A. Verify that setpoint has been | |
| A. Setpoint incorrect. |
| properly entered. |
CM III displays |
|
|
|
| B. | Disconnect unit from electrical | |
as it comes out of | B. Temporary controller malfunction |
| power, wait at least one minute, |
melt cycle | caused by voltage surge. |
| and reconnect unit to the power |
|
| supply. | |
OR |
|
| |
|
|
| |
Heating mode |
| C. | If available, substitute controller |
|
| known to be good for suspect | |
indicator does not |
|
| controller (see Section 6.6). If |
come on at all. | C. Failed controller. |
| fryer operates normally, order |
|
|
| replacement controller from |
|
|
| FASC. |
|
|
| |
|
| A. Refer to Burner will not light | |
| A. Burner is not lit. |
| problem on page |
Heating mode |
|
|
|
| B. | If available, substitute controller | |
indicator is on but |
|
| known to be good for suspect |
fryer is not heating |
|
| controller (see Section 6.6). If |
properly. | B. Failed controller. |
| fryer operates normally, order |
|
|
| replacement controller from |
|
|
| FASC. |
|
|
|
|