Frymaster H55 operation manual Reinstall the blower shield or shield assembly

4.Remove the plastic wrap from the blower motor assembly. Reassemble the blower motor assembly and blower housing. Reinstall the blower assembly in the fryer.

5.Reinstall the blower shield or shield assembly.

6.Light the fryer in accordance with the procedure described in Chapter 3, Section 3.1.

7.After the burners have been lit for at least 90 seconds, observe the flames through the burner viewing ports located on each side of the combustion air blower.

Left Viewing

Port is Behind

Motor

(NOTE: Blower shield omitted for clarity.)

Right

Viewing

Port

The air/gas mixture is properly adjusted when the burner manifold pressure is in accordance with the applicable table on page 2-7 and the burners display a bright orange-red glow. If a blue flame is observed, or if there are dark spots on a burner face, the air/gas mixture requires adjustment.

On the side of the blower housing opposite the motor is a plate with one or two locking nuts. Loosen the nut(s) enough to allow the plate to be moved, then adjust the position of the plate to open or close the air intake opening until a bright orange-red glow is obtained. Carefully hold the plate in position and tighten the locking nut(s).

TYPICAL BLOWER ASSEMBLY	SOME CE BLOWER ASSEMBLIES
	MAY BE CONFIGURED THIS WAY

5-5