Frymaster J2X Removing the Main Burner Assembly, Replacing Burner Deflector, Service Procedures

J1C, J1X, & J2X MASTER JET SERIES GAS FRYERS

CHAPTER 7: SERVICE PROCEDURES

5.Remove the pipe fittings from the old gas valve and reinstall on the replacement valve. Apply PST56765 Loctite pipe thread sealant to threads.

6.Reverse the previous procedures to install replacement gas valve.

7.7Removing the Main Burner Assembly

1.Disconnect the gas supply to the fryer.

2.Disconnect the control and high-limit wires at the gas valve.

3.Remove the drain nipple if stored inside the cabinet.

4.Loosen the pipe union to the left of the valve. See Figure 1, Item 6.

5.Remove the 2 burner hanger screws. See Figure 5.

6.Lower the front of the burner assembly and pull straight out to remove.

7.Reverse the previous procedures to re-install burner assembly.

7.8Replacing Burner Deflector

1.Disconnect the gas supply to the fryer.

2.Perform steps in Section 7.7 (Removing the Main Burner Assembly) to remove the burner assembly.

3.Using a 1/2 inch box end wrench or socket and ratchet, remove the 2 brass orifices that hold the target bracket to the burner manifold. See Figure 6.

4.Reverse the previous procedures to install the replacement deflector.

Figure 5

Figure 6

CAUTION

Use caution to prevent cross threading and stripping when reinstalling the brass orifices.

7-5