Frymaster J1X, J2X manual Alignment & Adjustment of Metal Burner Deflector, Replacing the Frypot

J1C, J1X, & J2X MASTER JET SERIES GAS FRYERS

CHAPTER 7: SERVICE PROCEDURES

7.9Alignment & Adjustment of Metal Burner Deflector

1.Proper alignment of all burner targets should be 3/4 inch between the top edge of the targets and the wall of the frypot.

2.To adjust targets, bend the deflector brackets away or toward the frypot to obtain the 3/4 inch measurement. See Figure 7.

Figure 7

7.10Replacing the Frypot

1.Drain all shortening from the frypot.

2.Disconnect the fryer from the gas supply.

3.If equipped, remove the frypot covers and basket hangers.

4.Remove the screws from the cowl and lift up and

off the fryer. See Figure 8 and Figure 1, Item 7. Figure 8

5.Remove the screws from the sides and back of the flue cap and remove the flue cap. See Figure 9.

6.Lift frypot complete with burner, gas valve, flue, drain valve, and combustion chamber from the fryer cabinet. After lifting frypot partially out of the cabinet, tilt the front of the pot up slightly to clear the drain valve.

7.Remove the burner assembly, flue, drain valve, and combustion chamber from the old frypot and install on the new frypot.

8.Reverse the previous procedures to install the new frypot assembly.

Figure 9

7-6