Frymaster MJCFE Replacing Burner Ceramic Targets cont, brass orifices, Service Procedures, 1-16

MASTER JET CF SERIES ATMOSPHERIC GAS FRYERS

CHAPTER 1: SERVICE PROCEDURES

1.8.9 Replacing Burner Ceramic Targets (cont.)

10.To replace only the ceramic targets, straighten the target locking tabs with a pair of needle nose pliers or a screwdriver, and slide the target up and off the bracket. Slide the replacement target onto the bracket and bend the locking tabs inward towards the burner target.

Remove damaged target by lifting up from bracket. Install new target and bend lock-tab in to lock target in bracket.

Straighten lock-tab to remove ceramic target.

To replace the entire target assembly, use a ½-inch (13 mm) box end wrench to remove the two brass orifices that hold the assembly to the burner manifold. Position the new assembly and replace the orifices.

WARNING

Use extreme care to prevent cross-threading and stripping when reinstalling the

brass orifices.

11.Reverse steps 1-8 to reinstall the burner assembly. Check spacing and alignment of targets in accordance with Section 1.6.

1-16