Frymaster Y/KSCF/C/HC18G 7.2.4, 7.2.5, remains after closing drain, valve, stops during filtering

Y/KSCF/C/HC18G HIGH EFFICIENCY COOL ZONE SERIES GAS FRYERS

CHAPTER 7: TROUBLESHOOTING

7.2 Fryer Troubleshooting (cont.)

		1.	KFC-1 SMS controller was turned OFF
			while draining frypot.
		2.	Close drain valve. Turn KFC-1 SMS
			controller OFF and ON again.
			Controller display will read ON.
		3.	Open drain valve. The KFC-1 SMS
			controller display will read DRAIN
			OPEN. After 30 seconds the controller
			display will read FILL.
7.2.4	DRAIN OPEN message	4.	Close drain valve.
	remains after closing drain	5.	Fill frypot with shortening. Press
	valve.
			EXIT/COOL FILTER when ready to
			cook.
		6.	If the KFC-1 SMS controller message
			DRAIN OPEN remains after Steps 1-
			4, contact an authorized service agent.
			Possible malfunctions are:
			a. Drain microswitch may be faulty.
			b. Drain circuit is suspect.
			c. KFC-1 SMS controller is suspect.
		1. The motor thermal overload has tripped. If
			the thermal overload trips, wait
			approximately 45 minutes. Press the
			button on the end of the filter motor.
7.2.5	Pump motor won’t start or	2.	If you have to do this repeatedly, stop
	stops during filtering.		resetting the overload and contact an
			authorized service agent.
		NOTE: This is usually caused by allowing
		large particles of food to enter the pump
		during filtering. Ensure that the filter paper
		and crumb screen are properly in place.

7-5