147
Settings
Store information from a barcode reader or GPS
connected to a 10-pin terminal as Exif information.
[BCR 1 SHOT]
Read barcode information for each shot and store it as
comment information. Pictures cannot be taken without
reading a new barcode.
[BCR CONTINUOUS]
Store registered barcode information as comment
information in every file. To erase the registered
information, read the “barcode eraser” on this page or
delete the letters registered in the [IMAGE
COMMENT].
[GPS]
Store information from GPS device allowing latitude,
longitude, altitude and UTC (standard universal
coordinated time) to be recorded with photographs.
[OFF]
No store barcord or GPS information is retrieved.
MEMO
When the barcode information is stored, BCD is
displayed in the control panel.
ZConnecting to barcode reader
You can use the barcode reader with a D-sub 9-pin
connector (commercially available).Connect the barcode
reader to the camera using MC-35. See the barcode
reader instruction manual for details.
Barcode reader setting
Baud rate: 4800 bps
Data length: 8 bit
Parity check: –
Stop bit: 1 bit
EOF: CR+LF
ZBarcode eraser
Use the barcode reader to read the barcode below to
erase the last barcode information.
Continued Q

BARCODE READER/GPS

How to use the SET UP menu (p.138)