208

Power Supply and Battery

ZBattery Features
The NP-150 gradually loses its charge even when not
used. Use a NP-150 that has been charged recently (in
the last day or two) to take pictures.
To maximize the life of the NP-150, turn the camera off
as quickly as possible when it is not being used.
The number of available frames will be lower in cold
locations or at low temperatures. Take along a spare
fully charged NP-150.
You can also increase the amount of power produced
by putting the NP-150 in your pocket or another warm
place to heat it and then loading it into the camera just
before you take a picture.
If you are using a heating pad, take care not to place the
NP-150 directly against the pad. The camera may not
operate if you use a depleted NP-150 in cold conditions.
ZCharging the Battery
You can use the battery charger BC-150 (included) to
charge the NP-150. When charging, use the NP-150
battery adapter supplied with the BC-150.
The NP-150 can be charged using the BC-150 Battery
Charger at ambient temperatures between 0°C and
+40°C (+32°F and +104°F). At an ambient
temperature of +23°C (+73°F), it takes approx. 135
minutes to charge a fully depleted NP-150 battery.
You should charge the NP-150 at an ambient
temperature between +10°C and +35°C (+50°F and
+95°F). If you charge the NP-150 at a temperature
outside this range, charging takes longer because the
performance of the NP-150 is impaired.
The NP-150 does not need to be fully discharged or
exhausted flat before being charged.
The NP-150 may feel warm after it has been charged or
immediately after being used. This is perfectly normal.
Do not recharge a fully charged NP-150.
ZBattery Life
At normal temperatures, the NP-150 can be used at least
300 times.
If the time for which the NP-150 provides power shortens
markedly, this indicates that the NP-150 has reached the
end of its effective life and should be replaced.
Notes on the Battery (NP-150)
This camera uses the rechargeable lithium-ion Battery
NP-150. Note the points below when using the
rechargeable battery. Take particular care to read the
Safety Notes to make sure that you use the battery
correctly.
*When shipped, the NP-150 is not fully charged. Always
charge the NP-150 before using it.
When carrying the NP-150, install it in a digital camera.