Fujitsu 1200 manual Changing System States, Power Icon, Current State, To Change State, Appearance

When you use the Stylistic 1200 pen tablet, you can change the current system state in a number of ways, depending on what state the system is in. To determine the current system state, observe the Power icon in the Status display. The following table gives the different system states represented by the Power icon and describes how you can change the system state from the current state. (Note that if the Power icon is not visible, either the Fully Off or Suspend-to-Disk state is indicated.)

Changing System States

Power Icon	Current State	To Change State*
Appearance
Power icon	Fully On,	To enter the Fully Off state, shut down
displayed	Idle,	and turn off the system.
continuously	or
		To enter the Suspend-to-RAM or
	Standby
		Suspend-to-Disk†state, suspend system
		operation.
Power icon blinking	Suspend-to-RAM†	To enter the Fully On state, resume
		system operation.
		To enter the Fully Off state, resume
		system operation, then shut down and
		turn off your system.
Power icon not	Fully Off	To enter the Fully On state, start your
displayed	or	system, or resume system operation.
	Suspend-to-Disk†

*Information in this table is supplied to help you understand which system states your system can enter from the current system state. Refer to the procedures on starting the system, shutting down the system, suspending system operation, and resuming system operation given later in this chapter for details on changing the current system state.

†Your system may be configured to use either Suspend-to-RAM mode, Suspend-to-Disk mode, or may use both modes sequentially. Contact your local help desk or reseller if your system configuration is unsuitable.

2-2 Using the Stylistic 1200 Pen Tablet