Fujitsu 1200 manual Charging the Battery Pack, Battery Pack Charging Time

Note that power to several system components must be restored before system operation resumes; allow sufficient time for system operation to resume before attempting to use the system. If your system uses Suspend-to-Disk mode, it will take several seconds longer to resume operation compared to using Suspend-to-RAM mode; time is needed to read data from the hard disk drive.

2. Use the system as you normally would once system operation resumes.

All programs resume at the point where execution stopped when system operation was suspended.

Charging the Battery Pack

The Stylistic 1200 battery pack can be charged while it is installed in the pen tablet. To do so:

1.Connect a DC power source, such as the AC adapter, to the DC input connector on the pen tablet. The DC Input icon appears in the Status display. If the battery pack charge level is below 90%, the battery pack begins charging and the Charging icon appears in the Status display. If the battery pack charge is 90% or higher when you connect DC power, the battery pack will not charge; this prevents overcharging the battery pack.

2.Look at the Battery Gauge icon in the Status display to determine the percent of charge in the battery pack. See “Status Display” in Chapter 1 of this manual for a description of the Battery Gauge icon.

As long as DC power remains connected to the pen tablet, the charging process continues until the battery pack charge reaches 100%. The amount of time needed to charge the battery pack is shown in the table below. Charge times shown here are for a fully discharged 9-cell battery pack charging while the pen tablet is not in use.

	Battery Pack Charging Time
Battery Pack Charge		Approximate Charge Time
	Level Reached
90%		3 hours
99%		4 hours
100%		5 hours

The pen tablet uses two charge modes to charge the battery pack, Fast Charge mode and Slow Charge mode. When the charge level is below 90%, the system charges the

Charging the Battery Pack 2-9