Fujitsu 1200 manual Solving Problems, System Will Not Resume Operation

4.In the dialog box, tap your response. (If you don’t tap any of the buttons within 20 seconds, your new calibration settings are discarded and previous calibration settings are used.)

•If you are satisfied that you tapped the cross-hairs accurately, tap OK. (The taps that you performed in step 3 are then used to calibrate the screen.)

•If you do not want to use your taps to calibrate the screen, tap Cancel.

•If you want to try again, tap Recalibrate. The calibration instructions reappear.

If you have successfully performed the procedure above, the pen is now calibrated, and you can use the system as you normally would.

Solving Problems

Solutions to some common problems are described in the following sections. If you are experiencing a problem with your Stylistic 1200 pen tablet that you cannot solve by taking the actions described, contact your local help desk or your reseller for further assistance.

System Will Not Resume Operation

If the system will not resume operation after suspending system operation, check the following possible causes:

•The system may be configured to use Suspend-to-Disk mode. If this is the case, you must turn the Power switch off and then on again to resume system operation. Note that the Power icon in the Status display does not blink when the system is configured to use Suspend-to-Disk mode.

•The battery pack may either be defective, or discharged to the critically low level. When the battery pack reaches the critically low level, the system is forced into Suspend-to-RAM mode to avoid a total system power failure. To correct this problem, either connect an external power supply (such as the AC adapter), or install a charged battery pack in the pen tablet.

•The system may be at the critical thermal limit. To avoid damage to heat-sensitive components, the system enters Suspend-to-RAM mode if it gets too hot. System operation cannot be resumed until the pen tablet cools off to a tolerable temperature. Move the pen tablet to a cooler location and prevent direct sunlight from shining on the pen tablet.

3-6 Care and Maintenance