
3 Power On
Cautions
● When turning on the PC for the first time after purchase, do not connect any peripheral equipment.
● The power lamp shines orange when the PC is in the standby mode.
● Before turning the PC power switch ON, make sure that the display unit has been connected to the PC. If the display unit is not connected, it is not recognized when you turn the PC power switch on. In such case, the
● If you use a digital display unit by plugging its power cord directly to the power receptacle, make sure that the power switch of the digital display unit is turned on before you turn the PC power switch on. If you turn the PC power switch on before turning on the power switch of digital display unit, nothing appears on the screen. In such case, turn the PC power switch off first, then turn the display and PC power switches on in the correct sequence.
● If you have connected the display power cord to the PC, the display unit is turned on when
you turn the PC power switch on. Therefore, you need not use the display power button later once you have pressed it.
The display unit is turned on just when you turn the PC power switch on in the step 2.
● If the window does not appear at the center of screen, check the display frequency for a setup error and correct it from the Control Panel of the PC. If the error continues,
● If you need to turn the PC power switch off immediately after its
● The PC screen may be distorted or it may show horizontal lines when starting to display the image or when changing the display mode (for example, when starting up or shutting down the Windows, or when recovering from the energy saving mode). This is not a fault, you can continue to operate.
● When the FUJITSU logo continues on the screen after you have turn the PC power switch on, the PC is checking its
● The PC screen may be distorted or it may show horizontal stripes instantaneously when the system starts up (including unpacking contract) or shut down. This is not a fault, you can continue to operate.
● If you have added a peripheral device to the PC, do not turn the PC power switch on while the PC upper cover is open.
● After you have turned the PC power switch off, wait at least 10 seconds before turning it on again. ● Check the following, if the screen is blank.
● The display power switch is turned on. ● The energy saving mode is not set.
Move the mouse or press any key. The PC may be shifted to S3 in the ACPI mode, if the standby lamp is orange. Press the power button. If the screen remains blank 30 seconds after you press the power button, then hold down the power button to turn the PC off.
● The display signal cable is connected correctly.
● The display power cord is plugged into the power receptacle.
● The display brightness and contrast controls are adjusted correctly. If not, adjust the screen with the
brightness and contrast controls.
19