No Message Cause Workaround
Master: Communicating as
Master
Slave: Communicating as Slave
3 Illegal value for [ParameterName]
An error was found with a
parameter defined in the
fjgi.conf file.
Check whether the value is set correctly
in the file.
4 fail to ddi_dma_bind_handle The driver could not allocate
DMA resources.
Installed physical memory may be
insufficient. If this is not the cause, report
this error to your service provider.
5 fail to FragCount An error was found in message
fragmentation.
Re-activate the interface. If this message
is still displayed, report to your service
provider.
6fjgi_param_register error The driver could not allocate
resources for the ndd parameter.
Installed physical memory may be
insufficient. If this is not the cause, report
this error to your service provider.
7fjgi_board_alloc_mem failed !! The driver could not allocate
resources.
8 Error filling TX ring The driver could not allocate
transmit resources.
9 status block can't alloced! The driver could not allocate
status information resources.
10 status block can't alloced handle!
11 status block can't bind handle!
12 fjgi_board_init_mem: Failed to
dma_alloc !!
The driver could not allocate
DMA resources.
13 statistic block can't alloced! The driver could not allocate
statistic information resources.
14 hwmib block can't alloced handle!
15 hwmib block can't bind handle!
16 fjgi_board_init_mem: Failed to dma
alloc2!!
The driver could not allocate
DMA resources.
17 Illegal value for LinkSpeed_A
The value of LinkSpeed_A in
the configuration file is
incorrect.
Set the correct value for LinkSpeed_A.
18 fjgi_hw_init:Step 22 failed An error occurred during
initialization of the adapter.
A hardware failure occurred. Please
contact your service provider.
19 fjgi_hw_init:Step 23 failed
20 fjgi_hw_init:Step 43 failed
21 Can't judge T or SX !! The adapter type cannot be
recognized.
Check whether the server is supported. If
the system is supported, there is a
possibility of hardware abnormalities.
Please replace the adapter.
22 (Other messages)
There is a possibility of driver
internal bug or hardware
failure.
Report the error to your service provider.
*1: This appears only when SE0X7GD1X/SE0X7GQ1X/SE0X7GQ2X are used in 1000Mbps environments.
Messages which are reported remotely by the Machine Administration function included in Enhanced Support Facility are listed in the
following table.
- 60 -