Contents of the Test Mode
The test mode includes the user test functions listed in the following table. This section explains “Offline feed test”, “Options”, and “Device life” which are necessary for users.
NOTE
If you need to use test functions other than “Offline feed test”, “Options”, and “Device life”, contact your dealer.
The user test functions are as follows:
Test item | Description |
|
|
|
|
Offline feed test | Scans sheets continuously for checking conditions of paper feeding. |
|
|
* Endorser test | Implements the Endorser‘s Print test. |
|
|
Options | Displays the options installed in the scanner. |
|
|
Device life | Displays the accumulative number of sheets fed and the accumulative number of hours for |
| lamps lit since the scanner has been installed, to estimate the life of the device. |
|
|
Sensor auto adjustment | Automatically adjusts sensors. |
|
|
Offset auto adjustment | Adjusts offset using adjustment sheets. |
|
|
Operation panel test | Tests functions of the LCD, LEDs, and buttons to check the operator panel. |
|
|
Revision Display | Displays the revision of the program EEPROM, |
|
|
Sensor status | Displays the status of the sensors. |
|
|
Sensor adjustment | Changes the current and slice level of sensors to adjust the sensors. |
|
|
white balance adjustment | Adjust the Amp Gain Value for R,G, B when put the white paper in to scanner. |
|
|
+5V voltage check | Displays the voltage of +5 volts. |
|
|
EEPROM edit | Writes arbitrary data in EEPROM (address 00 to FF) to confirm or change the set values. |
|
|
*If the option is not mounted, the set up item for the option does not display on the screen and skips to the next item.
