Connecting the SCSI interface cable
When using the scanner with the SCSI inter- face, you need to purchase a commercially available SCSI cable and a SCSI card.
•SCSI cable
The SCSI has to fit to a 50 Pin half pitch connector and the SCSI card connector of your PC.
•SCSI card
Use the recommended SCSI card noted on the fol- lowing website:
http://imagescanner.fujitsu.com/
| When connecting the SCSI interface |
ATTENTION | cable, be sure to first connect the SCSI |
| interface cable then turn on the scanner |
| and your PC. Connect the scanner so |
| that it is the terminated device on the |
| SCSI daisy chain. |
1. Connect the SCSI cable to the scanner.
Open the cable cover located below the ADF paper chute, connect the SCSI cable to the SCSI interface connector and make sure it is firmly connected.
Once the cable is connected, close the cable cover.
Be careful not to bend the pins of the
ATTENTIONSCSI cable when connecting to the scanner .
2. Connect the other end of the cable to your PC.
| For setting the SCSI ID of the scanner, |
HINT | please refer to the following section. |
Setting the SCSI ID
The factory default setting for SCSI ID is "ID 5". If the SCSI ID of another device has already been set to the same ID, change either the scanner's SCSI ID or that of the other device. To change the SCSI ID see the
following procedure.
1. Turn the scanner OFF.
2. Set the SCSI ID.
Open the cable cover located below the ADF paper chute and set the device address by using the SCSI ID switch.
|
| 4 |
| 5 | 6 |
| |||
| 3 |
|
|
|
| ||||
|
|
| 4 | 5 | 6 |
| 7 | ||
|
| 3 |
|
| |||||
|
|
|
|
|
| 7 | |||
|
|
|
|
|
|
| |||
| 2 | 2 |
|
|
| 8 |
| ||
|
|
|
|
|
| ||||
|
| 1 | 0 | 9 |
|
| |||
|
|
| 1 |
|
|
|
| ||
|
|
|
|
|
|
|
| ||
|
|
|
| 0 |
|
|
|
| |
|
|
|
|
|
|
|
|
| |
|
| TABLE 1. |
|
|
| ||||
No. | Description: |
|
|
|
|
|
| ||
0 - 7 | Can be set as the ID. |
| |||||||
8, 9 | Used for the factory default value | ||||||||
| (SCSI ID=5). |
|
|
|
|
| |||
3. Turn ON the Scanner.
When the scanner is turned ON, the SCSI ID set at step 2 is enabled.
4. Turn ON your PC.
2.3Installing the Scanner Application
For scanning documents with this scanner, the scanner driver as well as an image capturing application software (called "application" here- after) must be installed on your PC.
Scanner driver:
FUJITSU TWAIN 32 Scanner Driver FUJITSU ISIS Scanner Driver