the other device. To change the SCSI ID see the
following procedure.
1. Turn the scanner OFF.
2. Set the SCSI ID.
Set the device address by using the SCSI ID switch on the rear of the scanner.
| TABLE 1. |
|
|
No. | Description: |
|
|
0 - 7 | Can be set as the ID. |
|
|
8, 9 | Used for the factory default value |
| (SCSI ID=5). |
3. Turn ON the Scanner.
When the scanner is turned ON, the SCSI ID set at step 2 is enabled.
4. Turn ON your PC.
2.3.1For Fujitsu Twain 32 Scanner Driver
Preparation
Before installing the application, please confirm the following items:
•Keep the Setup
•Confirm if the scanner is connected to your PC correctly.
•If an older version of the FUJITSU TWAIN 32 Driver has already been installed, please uninstall it before installing the new one.
•There are two types of FUJITSU TWAIN 32 Drivers. Depending on the operating system (OS) of the computer, the most appropriate driver will be installed automatically.
•For Windows 98, Windows Me, Windows 2000, Windows XP:
FUJITSU TWAIN32 V9
•For Windows 95 and Windows NT 4.0:
FUJITSU TWAIN32 V8
•When using Windows 95 or Windows NT 4.0: ASPI Manager 4.01 or later is required (generally comes with SCSI board products).
2.3Installing the Scanner Application
For scanning documents with this scanner, the
HINT
For details on connecting the scanner, refer to "2.1 Installing the scanner" on page 2 in this manual.
Uninstall [Scanner Utility for Microsoft
scanner driver as well as an image capturing application software (called "application" here- after) must be installed on your PC.
Scanner driver:
FUJITSU TWAIN 32 Scanner Driver FUJITSU ISIS Scanner Driver
Application:
ScandAll 21 (for TWAIN)
QuickScan Pro (for ISIS)
ATTENTIONWindows] in [Add/Remove Programs] of the control panel.