Appendix 4 Setting the position of the

ADF

- For left-handed operators

As the factory default, ADF of fi-5750C is fixed with ADF lock screws. Be sure to remove the screws before changing the position of the ADF.

ADF can be set to the following three posi- tions:

•Type 1: Traditional

-Traditional style of previous FUJITSU scanner products

-For operators accustomed to previous FUJITSU scanners

•Type 2: Standard

-Small foot print

-For right-handed operators

Type 2 and 3 are available only when the ADF is set to the center position. Before changing the ADF position to Type 2 or 3, slide the ADF to the center position. When the ADF is in Type 2 position, you can change the position to Type 3 by rotating the ADF in 180 degrees and vice versa.

For details on setting the ADF, refer to 2.2 “Setting the ADF” of “fi-5750C Operator’s Guide” on Manual CD-ROM.

CAUTION

Take care not to pinch your fingers when rotating the ADF.

•Type 3: Reversed - Small foot print

• Please rotate the ADF after you set

ATTENTION

the stacker upright.

•When you change the position of the ADF, do not rotate it over 180 degrees, other wise the ADF may be damaged.

AP-9