7. Check the scanned data.
8.Press the [OK] button.
⇒The "Maintenance" screen is shown again.
■If Scanning Completes SuccessfullyContinue with the setting procedures described in Chapter 1 of the "Network Scanner
System settings or user data can be
HINT |
| backed up from [Maintenance], [User Data |
|
| |
|
| Store] or [System Settings File]. This can |
|
| only be performed via Web interface. |
|
| Backup should be performed regularly. |
|
| For more details, refer to the "Network |
|
| Scanner |
If the top cover is open
•Message
Top cover may be open. Close the top cover, reload the documents and try again.
•Action
Click the [OK] button on the error dialog to return to the "Maintenance" screen. Close the top cover, and try the scan test again.
If no document is loaded
•Message
Document not found. Load a document into the ADF, making sure the side guides are adjusted correctly and try again.
•Action
Click the [OK] button on the error dialog to return to the "Maintenance" screen. Load a document, and try the scan test again.
If a multifeed is detected
•Message
Feed Error: Document(s) may not match the set paper size, ADF may have grabbed more than one sheet, or documents may not be suitable for scanning. Remove the documents from the ADF, check them and try again. If problem persists, consult the manual.
•Action
Click the [OK] button on the error dialog to return to the "Maintenance" screen. Remove the document for which multifeed was detected, and try the scan test again.
If a paper jam occurs
•Message
Paper jam has occurred. Remove the documents from the ADF and try again.
•Action
Click the [OK] button on the error dialog to return to the "Maintenance" screen. If the "Scan Viewer" screen appears with partially scanned data, just click the [OK] button. Remove any unscanned documents from the ADF. Open the scanner's top cover, remove the jammed document from the scanner, and close the scanner's top cover. From the "Maintenance" screen, try the test scan again.
If a USB cable becomes disconnected
•Message
Scanner initialization has failed. Try turning the power off and back on again. The administrator should contact the FUJITSU scanner dealer or an authorized FUJITSU scanner service provider for help.
•Action
Click the [OK] button on the error dialog to return to the "Maintenance" screen. Check that all cables are firmly connected, and try the scan test again.
If an error occurs
•Message
An error has occurred. Try turning the power off and back on again. The administrator should contact the FUJITSU scanner dealer or an authorized FUJITSU scanner service provider for help.
•Action
Click the [OK] button on the error dialog to return to the "Maintenance" screen. Contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
12