Fujitsu FPCR35161, FPCR47651 You have a secured system, On the screen during Detected a problem

Problem	Possible Cause	Possible Solutions
The system powers up, and	You have a secured system	Make sure you have the right password. Enter the setup utility and verify the Security
displays power on informa-	requiring a password to load	settings and modify them as accordingly. See “BIOS Setup Utility” on page 38.
tion, but fails to load the	your operating system.
operating system.
(continued)
Error message is displayed	Power On Self Test (POST) has	See the Power On Self Test (POST) messages to determine the meaning and severity of
on the screen during the	detected a problem.	the problem. Not all messages are errors; some are simply status indicators. LIFEBOOK
notebook (boot) sequence.
Your notebook appears to	BIOS setup changes were not	Make sure you select Save Changes And Exit when exiting the BIOS setup utility.
change setup parameters	saved before you exited the
when you start it.	utility.
	The BIOS CMOS hold-up bat-	Contact your support representative for repairs. This is not a user serviceable part but
	tery has failed.	has a normal life of 3 to 5 years.
Video Problems
The built-in display is blank	The notebook is set for an	Pressing [F10] while holding down the [Fn] key allows you to change your selection of
when you turn on your LIFE-	external monitor only.	where to send your display video. Each time you press the keys you will step to the
BOOK notebook.		next choice. The choices, in order are: built-in display only, external monitor only, both
		built-in display and external monitor.
	The display angle and bright-	Move the display and the brightness control until you have adequate visibility. Press-
	ness settings are not adequate	ing either the [F6] or [F7] keys while holding down the [Fn] key also allows you to
	for your lighting conditions.	change the brightness level of the display.
	Power management timeouts	Press a keyboard button or move the mouse to restore operation. If that fails, push the
	may be set for short intervals	Power/Suspend/Resume button. (The display may be shut off by Standby mode, Auto
	and you didn’t see the display	Suspend or Video Timeout)
	come on and go off.
The notebook turned on	Power On Self Test has	Contact your support representative.
with a series of beeps and	detected a failure which does
the built-in display is blank.	not allow the display to oper-
	ate.

73 - Troubleshooting