Fujitsu M3093GX, M3093EX manual 1 Check items continued, Paper double feed

Table 6.1 Check items (continued)

Problem	Possible cause	Response
The check	The carrier fixing bracket	Remove the carrier fixing bracket as
indicator is on.	was not removed.	explained in Section 3.2, “Removing the
		Carrier Fixing Bracket.”
	——————————	Turn the power off then on again. If the
		check indicator turns on again, contact the
		sales person in charge or a Fujitsu service
		representative.*
“Check” lamp	The pick roller is dirty.	When the power is turned off, the mes-
blinks at 4		sage is cleared.
seconds period.		Even if the message is displayed, the read
		operation can be continued. Clean the
		pick roller after the read operation.
		(See Section 5.3.2.)
	The unallowable document	If a document not meeting the scanner
	was read in the automatic	specifications is read in the automatic
	document feeder.	document feeder, the document is not fed
	(See Section 4.3.)	smoothly and an error message may be
		displayed.
		Read the document in the flat bed station.
Paper double feed.	Pad is dirty.	Clean the Pad. (See Section 5.3.2)
	Pad is worn out.	Replace the Pad. (See Section 5.4.2)
Miss pick.	Pick roller is dirty.	Clean the Pick roller. (See Section 5.3.2)
	Pick roller is worn out.	Replace the Pick roller.
		(See Section 5.4.3)
Paper jam.	Some foreign particles are in	Clean the ADF (See Section 5.3.2) or
	ADF.	remove any foreign particles.

*Please check the test mode in appendix B, if possible, before calling the service representa- tive and inform status of the indicators.

6 – 2