7Open the right and left guides of the ADF paper chute about 5 mm wider than the document width.
8Place the documents face down onto the ADF paper chute with the top edges facing the automatic feeder hole.
9Adjust the guides to the document sides. Skewing may occur if there is a gap between the guides and documents.
10Slide the documents down until they touch the far end of the automatic feeder opening. If the documents hit the far end hard, two or more pages may be fed at once. Make sure that the upper end of documents are not turned.
11Read the document. If a wrong document size or mode (portrait or landscape) is selected, the document may not be read entirely.
NOTICE: Unless 3 mm of the leading edge of forms are not white or dropout color, set the document type to "Photo."
12After reading, remove the documents from the stacker.
Guide
Automatic document feeder
Documents
ADF paper chute
Guide lever (Both sides)
Guide
Figure 4.4 Loading the document
Portrait | Landscape |
Short side | Long side |
Automatic document feeder
ADF paper chute
Documents
4 – 9
