
CHAPTER 2 CONNECTING THE EMULATOR
2.4Connecting a Probe
Connect a probe to the adapter board.
■Connecting a probe Note:
The adapter board has two pairs of probe connectors. Do not use both pairs at the same time. Use only one of these pairs according to the configuration of the probe used.
■Connecting a probe (using a probe cable)
CAUTION
Make sure that power to the product is turned off and the power plug is
Prohibition disconnected from outlets before connecting or disconnecting cables. Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable. Always grasp the power plug or connector itself. Pulling the cable may expose conductors or sever wires in it, possibly resulting in device problems, fire, or electric shock.
Connect a probe cable to probe connectors A1 and A2 on the adapter board, as shown in Figure
Figure 2.4-1 Connecting a probe (using a probe cable)
Probe cable
PROBE CN A1 | PROBE CN A2 | ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PROBE CN B1 PROBE CN B2
Adapter board
28