2.4 Connecting a Probe
■Connecting a probe (using flat cables)
CAUTION
Make sure that power to the product is turned off and the power plug is
Prohibition disconnected from outlets before connecting or disconnecting cables. Doing so may result in device problems or electric shock.
Do not grasp the cable when unplugging the power plug and cable. Always grasp the power plug or connector itself. Pulling the cable may expose conductors or sever wires in it, possibly resulting in device problems, fire, or electric shock.
Connect flat cables to probe connectors B1 and B2 on the adapter board, as shown in Figure
Figure 2.4-2 Connecting a probe (using flat cables)
Adapter board
PROBE CN A1 | PROBE CN A2 | ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PROBE CN B1 | PROBE CN B2 |
Flat cables
Eject locks
To connect a flat cable, push its connector into probe connector B1 or B2 until the eject locks on both sides of the flat cable connector lock.
To disconnect a flat cable, pinch the eject locks on both sides of the flat cable connector until the flat cable unlocks, and pull out the connector.
29
