Manuals / Brands / Photography / Photo Scanner / Fujitsu / Photography / Photo Scanner

Fujitsu P3PC-1932-01EN Appendix3, Appendix3 REPLACING CONSUMABLES, ■Consumables and Replacement Cycle, ■Replacing the Pad ASSY, ■Replacing the Pick Roller, AP-5

1 28

Download 28 pages, 1.29 Mb

Appendix3 REPLACING CONSUMABLES

	During its operation, the inside
	During its operation, the inside
	glass of the ADF becomes very
	hot .
	Before replacing the
	consumables, turn its power off
	and unplug the AC adapter from
	the outlet. Wait at least

15minutes.

■Consumables and Replacement Cycle

The followings are the specifications of consumables and their recommended replacement cycles.

	Description	Parts No.	Standard
	Description	Parts No.	Replacement Cycle
			Replacement Cycle


	Pad ASSY	PA03334-	After 100,000 scans or
		0002	one year

	Pick roller	PA03334-	After 200,000 sheets
		0001	or one year

To purchase consumables, contact the store where you purchased the scanner or an authorized FUJITSU scanner service provider.

The replacement cycles above are rough guidelines when using A4/Letter woodfree or wood containing

paper 64 g/m2 (17 lb). This cycle varies according to the type of the used paper and how frequently the scanner is used and cleaned.

The following illustrations show the locations of the consumables. For details, refer to chapter 4 "Replacing Consumables" of "fi-5530C2 Operator’s Guide" on the Setup CD-ROM.

■Replacing the Pad ASSY

To remove

To attach

Pad ASSY

■Replacing the Pick Roller

Sheet guide

ATTENTION

Use only the specified consumables.

Pick roller

AP-5

Contents

fi-5530C2Image Scanner Page CONTENTS ■ Regulatory Information ■ Note of Liability ■ Safety Precautions Chapter1 INTRODUCTION ■Regulatory Information FCC declaration Canadian DOC Regulations Bescheimigung des Herstellers / Importeurs ■Note of Liability Use in High-safetyApplications Trademarks How Trademarks Are Indicated In This Manual About the use of mercury Manufacturer About Maintenance Warning Label Warning Indications Used In This Manual Symbols Used In This Manual ■Safety Precautions Do not install the scanner on unstable surfaces Do not block the ventilation ports Do not place heavy objects or stand on top of the scanner Firmly insert the power plug Avoid any contact when scanner is in use Chapter1 PREPARING THE SCANNER 1.1Checking the Contents of the Scanner Package 1.2 Names of Parts ■Front side ■Rear side 1.3 Operator panel ■Indications on the Function Number Display Chapter2 INSTALLATION OF THE SCANNER 2.1 Installing the Scanner 2.2Connecting the Scanner to Your Personal Computer ■Connecting with the USB Interface Cable ■ Connecting with the SCSI Inter face Cable ■Setting the SCSI ID 2.3Installing the Scanner Software ■Preparations ■Installing the FUJITSU TWAIN32 Scanner Driver 4.Insert the Setup CD-ROMinto the CD drive ⇒<SETUP DISK START UP SCREEN> appears Install the driver, following the on-screen instructions When you see the [InstallShield Wizard Com ■Installing the FUJITSU ISIS Scanner Driver ■Installing ScandAll PRO Proceed with the installation, following the on screen instructions When the [InstallShield Wizard Complete] dia log box appears, click the [Finish] button Error Recovery Guide Adobe® Acrobat® 1.Insert the Adobe Acrobat CD-ROMinto the CD-ROMdrive ⇒The [Adobe Acrobat] dialog box appears 3. In the dialog box below, click the [Next] button 2.4Checking Scanner Driver Operation ■Checking the Operation of the Scanner Driver Page 2.5Uninstalling Supplied Programs Appendix1 TROUBLESHOOTING Appendix1 ■Troubleshooting checklist AP-1 AP-2 ■Temporary error ■Device alarm (Permanent error) AP-3 Appendix2 DAILY CARE ■Locations and Cycle for Cleaning ■Cleaning Method AP-4 Appendix3 REPLACING CONSUMABLES Appendix3 ■Consumables and Replacement Cycle ■Replacing the Pad ASSY ■Replacing the Pick Roller AP-5 AP-6 fi-5530C2Image Scanner Getting Started