44 SPARC Enterprise T5140 and T5240 Servers Installation Guide • February 2008
Enabling the Service Processor NetworkManagement Port
The service processor network management port is not operational unless your
network employs DHCP,in which case the configuration in automatic. If you
network uses DHCP,you can run this command
to view your server’s network configuration information. For example,
If your network does not use DHCP,the network management port is not
operational until you configurenetwork settings for the service processor. Configure
the service processor in this order:
1. After the service processor boots, access the ILOM CLI through the serial
management port. See “ToLog Into the Service Processor Using the Serial
Management Port” on page 45.
-> show /SP/network
-> show /SP/network
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_server_ip = 10.8.31.5
ipaddress = 10.8.31.188
ipdiscovery = dhcp
ipgateway = 10.8.31.248
ipnetmask = 255.255.252.0
macaddress = 00:14:4F:7E:83:4F
pendingipaddress = 10.8.31.188
pendingipdiscovery = dhcp
pendingipgateway = 10.8.31.248
pendingipnetmask = 255.255.252.0
state = enabled
Commands:
cd
set
show