Chapter 3 Powering On the System 51
▼To Power On the System
1. Performthe following steps to verify that there are no faults:
a. Setthe virtual keyswitch to diag mode so that POST will run in Service
mode.
b. To initiate the power on sequence, type the start /SYScommand.
Youwill see an ILOM CLI alert message on the system console. This message
indicates that the system has reset.
-> set /SYS keyswitch_state=diag
Set ’keyswitch_state’ to ’diag’
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
->