Chapter 3 Powering On the System 45
2. Configure the service processor. See “To Configure the Service ProcessorNetwork
Management Port” on page 47.
3. Commit the changes to the service processor parameters. See Step 5 in “To
Configure the Service ProcessorNetwork Management Port” on page 47.
Youcan now use the network management port at any time to access the service
processor.See “To Log Into the Service Processor Using the Network Management
Port” on page 50.
Logging Into the Service Processor
If you are powering on the system for the firsttime after installation, use the service
processor serial port to power on the system and run POST.See “To Log Into the
Service Processor Using the Serial Management Port” on page45.
If the network management port has already been configured,you can use it instead
of the serial management port. See “ToLog Into the Service Processor Using the
Network Management Port” on page 50.

▼To Log Into the Service Processor Using the

Serial Management Port

After the service processor boots, access the ILOM CLI to configureand manage the
system. The ILOM CLI prompt (->) is displayed at the first time the service
processor is booted. The default configuration provides an ILOM CLI root user
account. The default root password is changeme. Change the password using the
service processor ILOM CLI password command.