Fujitsu XG0224 manual Connecting SFP Module

XG0224 Hardware Guide Chapter 2 Installation

Connecting SFP Module

Firmly install SFP module to SFP slot and lock module to the switch.

SFP module

100BASE-FX/ 1000BASE-SX/1000BASE-LX/ 1000BASE-ZX/1000BASE-BX-D/ 1000BASE-BX-U

Caution

Make sure to turn off the power when inserting and pulling out the SFP module.

Precautions

•Port 21 to 24 of 10/100/1000 BASE-T port and the same number ports of SFP port cannot be used at the same time. Connect only ports that will be used with twist pair cable or optical cable with SFP module.

•Make sure use 1000BASE-BX-D SFP module and 1000BASE-BX-U SFP modules in pairs.

•Safely keep a guard cap of SFP module.

•Make sure to clean the end face of SFP module / optical cable before connecting optical connector because the end face may possibly be contaminated. Please refer to "2.3.2 Cleaning SFP Module / SFP+ Module / Optical Connector" (pg.35) for cleaning.

•Do not directly touch the contact part of SFP module by hands. Use wristbands when touching SFP module.

•Connecting part to the optical cable of SFP module is the laser opening.

There are two types of SFP modules, veil latch type and standard latch type.

Below describes how to connect these modules.

•Veil Latch Type

Insert SFP module to the SFP slot with a lever locked, and lock the module and the switch. Connect optical cable (connector shape: LC) after inserting SFP module to the SFP slot.

When removing SFP module, unlock the lever, module and the switch, and remove the module after unplug the optical fiber.

Lever

•Standard Latch Type

Insert SFP module to the SFP slot, and lock the module and the switch.

Connect optical cable (connector shape: LC) after inserting SFP module to the SFP slot.

When removing SFP module, remove the module after pressing a tab to unlock the module and the switch.

Tab

38 Connecting the Equipment