CONNECTIONS
Connecting to TV
Rear panel of STB
AUDIO OUT | VIDEO | |
R | L | OUT |
ANT. IN | ANT. ΟUΤ |
To audio input jacks (L, R)
Video cable
Audio cable
AND/OR
To video input jack
To antenna input jack
Supplied cables used in this connection are as follows:
•RF cable x1
Please purchase the rest of the necessary cables at your local store.
RF cable
Before connecting, ensure the AC power cords of all devices are NOT connected to the AC outlets.
1Refer to “Connecting an Antenna” on page 9 to connect the STB to an antenna.
2Use an RF cable to connect the ANT. OUT jack on the STB to the antenna input jack on the TV.
AND/OR
Use a standard audio/video cable to connect the AUDIO/VIDEO OUT jacks on the STB to the audio/video input jacks on the TV.
3Plug all AC power cords into AC outlets, then turn all devices on.
4After you have completed the connections, select an appropriate external input channel on your TV (ch3 or ch4) (refer to your TV’s manual for details), and also set the STB’s output channel to the corresponding channel number (3 or 4). You can switch between 3 and 4 by holding [SETUP] down over 3 seconds.
NOTE:
•When using either of these connections, the resolution of the video signal output will always be 480i. This ensures that all digital TV programming, no matter what the actual transmitted format is, will be viewable and compatible with your analog TV.
•If your TV is monaural (MONO) and has only one audio jack, connect a standard audio cable (white) from the AUDIO OUT (white) jack on the STB to an audio input jack (white) on the TV. The red cable and jack will not be used.
10
EN
X6040UD_Connections_02_03.indd 10
2007/11/20 22:25:33
