FUNAI TB100MW9 owner manual Selecting Display Mode, Select Display Mode using K / L, then press OK

ADVANCED OPERATION

4Select “AUTOSCAN” using [K / L], then press [OK].

AUTOSCAN		AUTOSCAN
			The system is now scanning
EXIT	AUTOSCAN will rescan all channels.
CHANNEL	This may take a while to complete.
TIME	BACK		12%		Channel Found
DETAIL	AUTOSCAN
				EXIT
INITIAL

3Select “DISPLAY MODE” using [K / L], then press [OK].

DETAIL

EXIT	V-CHIP
CHANNEL
	CLOSED CAPTION
TIME
DETAIL	DISPLAY MODE	LETTERBOX
	AUTO POWER DOWN		4 HOURS
INITIAL

•STB starts receiving available digital channels and stores them in the channel map.

•When the scanning is complete,

“AUTOSCAN COMPLETED” will be indicated.

•After autoscan is complete, press [CH / ] to verify whether STB is receiving channels properly.

To cancel during scanning:

Press [SETUP] or [OK].

NOTE:

•If canceled, some channels not yet scanned may not be received. We recommend completing autoscan.

•When you want to completely refresh the channel map, delete all the channels, then do the autoscan again. See “Adding/Deleting Channels” on page 17 for details.

When “NO SIGNAL” appears on the screen:

Verify the antenna connection, then scan again. The STB tunes in channel 2-1 and “NO SIGNAL” appears if the STB could not receive any channels.

Selecting Display Mode

STB allows you to select a display mode to match the formats of the program being broadcast on your TV screen.

Display Mode

4 Select the desired display mode using [K / L], then press [OK].

Select display mode

LETTERBOX

ZOOM

FULL

5 Press [SETUP] to exit “SETUP” menu.

OPERATION ADVANCED

1Press [SETUP] to display “SETUP” menu.

2Select “DETAIL” using [K / L], then press [OK].

SETUP
EXIT
	V-CHIP
CHANNEL
	CLOSED CAPTION
TIME
	DISPLAY MODE	LETTERBOX
DETAIL	AUTO POWER DOWN
			4 HOURS
INITIAL

19

EN

X6040UD_Book.indb 19

10/22/2007 5:09:18 PM