1.5Adjusting Display Contrast, Brilliance
1.Press the [POWER/BRILL] key momentarily to show the brilliance/contrast adjustment window.
BRILL/CONTRAST
TX/STBY - PRESS [MODE]
| LOW | HIGH | ||
CONT: |
| 4 |
|
|
|
|
|
|
|
| LOW | HIGH | ||
BRILL: |
|
|
|
|
|
| 9 |
| |
|
|
|
|
|
[MENU/ESC] : Exit.
Brilliance/contrast adjustment window
2.Press ◄ or ► to adjust contrast.
3.Press ▲ or ▼ to adjust brilliance.
4.Press the [MENU/ESC] key to escape.
Note 1: Windows other than menu windows are erased when there is no operation within about 10 seconds.
Note 2: When the power is reapplied after turning off the equipment with minimum brilliance, the radar starts up with minimum brilliance, after the startup screen appears. Adjust the brilliance as necessary.
1.6 Choosing the Range
The range selected automatically determines the range ring interval, the number of range rings and pulse repetition rate.
Press the [RANGE+] or
1. OPERATION
Range 
6.0 nm
Range ring | 2.0 |
| |
interval |
|
EBL - - |
| RNG 03.2nm |
VRM - - - |
| BRG 60.2° |
| TTG 02H21M | |
|
|
|
Location of range and range ring
interval indications
1.7 Receiver Sensitivity
The [GAIN] key adjusts the sensitivity (gain) of the receiver. It works in precisely the same manner as the volume control of a broadcast receiver, amplifying the signals received.
The sensitivity is adjusted automatically according to sea conditions, and you may also further adjust it manually to fine tune. The proper setting is such that the background noise is just visible on the screen.
If you set up for too little sensitivity, weak echoes may be missed. On the other hand excessive sensitivity yields too much background noise; weak targets may be missed because of the poor contrast between desired echoes and the background noise on the display.
1.Press the [GAIN] key consecutively until the display shown below appears.
GAIN
AUTO : MODERATE
MANU20
[GAIN] : A/C SEA MENU
[MENU/ESC] : Exit.
Gain adjustment window
4
