1.OPERATION
1.23PROG Key
The [PROG] key acts as a menu shortcut key. You may use any User menu item except “SYSTEM MENU.”
Using the PROG key
1.Press the [PROG] key. The options window corresponding to the item programmed appears. In the example below the echo stretch options window is shown.
ECHO STRETCH
OFF
LOW
HIGH
Echo stretch options window
2.Press ▲ or ▼ to choose appropriate option.
3.Press the [MENU/ESC] key to close the options window.
Programming the PROG key
1.Press the [MENU/ESC] key to open the User menu. “P” marks the current function of the [PROG] key.
|
|
|
|
|
|
|
| ||
| INT REJECTION | : LOW |
| |
P ECHO STRETCH | : LOW |
| ||
| FTC | : OFF |
| |
| NOISE REJECTION: LOW |
| ||
|
| |||
|
|
| (1/2) | |
| [MENU/ESC] : Exit. | |||
|
|
|
|
|
User menu, page 1
2.Press ▲ or ▼ to choose the item you wish to use.
3.Press and hold down the [PROG] key (about three seconds) until you hear a beep. The “P” moves to the item selected.
4.Press the [MENU/ESC] key to close the menu.
1.24Outputting Target Position to a Plotter
If the radar is interfaced with a plotter, you can output target position to the plotter, and show that position on the plotter’s screen with the target mark (X). This function requires position and heading data.
1.Use the cursor pad to place the cursor on a target.
2.Press the [MARK] key to show the Mark menu.
MARK MENU
[GAIN] : EBL
[ALARM] : VRM
[MARK] : TLL OUTPUT
Mark menu
3.Press the [MARK] key again to output cursor position.
4.Press the [MENU/ESC] key to close the menu.
13
