Display unit, rear view
3.Close the rear panel, making sure the gasket is correctly positioned.
4.Plug in the connector of the external buzzer to J6 on the DU Board.
5.Seal the hole with sealing compound.
6.Fix the buzzer to the location desired with two tapping screws.
3.4 Adjustments
After you have installed the radar, do the heading alignment and timing adjustment. If you are connecting external equipment, follow “NMEA port setup, GPS WAAS setup” (for
Heading alignment
You have mounted the antenna unit facing straight ahead in the direction of the bow. Therefore, a small but conspicuous target dead ahead visually should appear on the heading line (zero degrees).
In practice, you will probably observe some small error on the display because of the difficulty in achieving accurate initial positioning of the antenna unit. The following adjustment will compensate for this error.
1.Turn on the power while pressing and holding down the [MENU/ESC] key. Continue pressing the [MENU/ESC] key until the Installation menu appears.
3. INSTALLATION
INSTALLATION MENU
SIMULATION |
| OFF |
TEST ... |
| |
LCD PATTERN ... |
| |
MEMORY CLEAR |
| |
NMEA PORT | : IN/OUT | |
NMEA OUTPUT | : OFF | |
GPS WAAS | : OFF | |
GOTO RADAR SETUP...
Installation menu
2.Press ▼ to choose GOTO RADAR SETUP.
3.Press ►. Power is then reset.
4.Wait one minute, press the [POWER/BRILL] key and then press the [MODE] key to transmit.
5.Press the [MENU/ESC] key to show the User menu.
6.Press ► to show the Radar Setup menu.
RADAR SETUP
HEADING ADJUST |
|
TIMING ADJUST |
|
SET ON TIME | : 000000h |
SET TX TIME | : 000000h |
[MENU/ESC]: Exit.
Radar setup menu
7.HEADING ADJUST is selected; press ► to show the options window.
RADAR SETUP
HEADING ADJUST |
| : YES |
|
TIMING ADJUST |
| : NO |
|
SET ON TIME |
| : 000000h |
|
| |||
SET TX TIME |
| : 000000h | |
[MENU/ESC]: Exit.
Radar setup menu (heading adjust)
27
