3. INSTALLATION
7.Referring to the figure below, fasten the shield cable with a screw (M4x10) on the chassis to ground the unit.
Connect 9 pin
Push down here
Top cover
Less than 1 mm
Antenna base
How to fix the cover
Note: If you need to measure magnetron voltage, temporarily fasten cover bolts so you can open the cover later.
connector
Connect shield here.
Mounting using the optional mounting
here (J801).
How to connect the antenna cable
to the antenna unit
8.Attach the EMI core to the antenna cable. Set the EMI core fixing plate to the EMI core.
Pass the cable through the plate so the bend faces downward.
EMI core fixing plate
9.Connect the
10.Refasten the shield plate with 10 screws. Be sure not to pinch the cable from the rotation detector with the shield plate.
11.Fasten the EMI core fixing plate with screw (supplied).
Screw (M4x15)
Align bend with corner of chassis.
EMI Core
Fixing Plate
EMI Core
How to fix the EMI core
12.Close the cover. To fix the cover, push down on the cover evenly to close and then tighten cover fixing screws (3).
Confirm that there is no more than 1 mm gap between the top cover and the antenna base.
bracket
A mounting bracket for fastening the antenna unit to a mast
Contents of mounting bracket kit
Name | Type | Code No. | Qty | |
Bolt | M4x12 | 4 | ||
Bolt | M8x20 | 8 | ||
Mounting | 1 | |||
plate | ||||
|
|
| ||
Support | 1 | |||
plate (1) | ||||
|
|
| ||
Support | 1 | |||
plate (2) | ||||
|
|
| ||
Bracket (1) | 1 | |||
Bracket (2) | 1 | |||
Fixing plate | 2 |
1.Remove mounting hardware at the bottom of the antenna base. You may discard the mounting hardware.
2.Assemble the mounting bracket as below and fasten it to a mast.
3.Fasten the antenna unit to the mounting bracket with hexagon head bolts (M10x25, optional supply).
24
