3.Using the hexagon head bolts, flat washers and spring washers removed at step 1, fasten the antenna unit to the platform. The torque should be
| Antenna | |
| base | |
Effective |
| |
thread |
| |
length |
| |
15 mm | *t | |
Flat |
| |
washer | Platform | |
| ||
Spring | Apply silicone | |
sealant. | ||
washer | ||
Hexagon head bolt | ||
| ||
| (M10 x 20 or M10 x 25) |
*t: Platform thickness |
| Bolt to use | ||
| 5 mm or less: |
| M10 x 20 |
|
|
| M10 x 25 | ||
| over 10 mm: |
| locally supplied bolts | |
How to fasten the antenna
unit to the platform
4.Unfasten three screws to open the cover. Release the cable of the rotation detector from the cable clamp.
3. INSTALLATION
Shield plate
Discard this screw.
Antenna unit, cover removed, top view
6.Pass the antenna cable with connector through the gasket and cable clamp, and then tighten cable gland. Two gaskets are supplied: one gray, one black. Use the proper gasket according to antenna cable used, referring to the illustration below.
Rotation 
detector
Cable Gland
Rubber
Gasket
Gasket (See below for type to use.)
Cable 
clamp
Cable entrance
Antenna unit, cover removed, top view
5.Referring to the illustration at the top of the next column for location, unfasten 11 screws to dismount the shield plate. Discard the screw circled in the illustration.
67
φ 12
Use gray gasket.
49
φ 11
Use black gasket.
Antenna unit, top view
23
